Unusual original Nintendo 3DS motherboard revision: CTR-CPU-40

DSCF9148

I received a 3DS console today that had been cracked in half at the hinge. As I opened it up to remove the motherboard I immediately noticed that the tiny little IR board that normally connects to a plug next to the P7 connector was missing. The IR module on this motherboard was integrated and not removable. Also strange was the fact that the little piece of tape used at the factory to secure the touch screen connector was black, rather than the typical white. I’ve seen a few boards with black tape rather than white, but in the past I always assumed this was because they had already been worked on before I received them and the last technician had used black tape. Now I know I was probably wrong. This was an entirely new motherboard revision.

The back of the board

The back of the board

Integrated IR

Integrated IR

There are some minor yet consistent differences I’ve noticed from one console to the next, such as the color of the mainboards, color of screws, slight variations in the labeling on the WiFi board, and the fact that most special edition consoles and consoles bundled with a game have the charge ports soldered much more securely to the board than the original black/red/blue models. Normally, however, the motherboard itself is basically the same. This is different from those types of minor variations because it’s a completely different motherboard revision from what I’ve seen before. Though it’s not something I normally pay attention to, I don’t think I recall ever seeing anything other than CTR-CPU-01 and the occasional CTR-CPU-20 boards.

Big blobs of solder secure the charge port in place, unlike the weak connection in earlier models

Big blobs of solder secure the charge port in place, unlike the weak connection in earlier models

The label on the WiFi daughterboard differs slightly from most models, but the board itself is the same DWM-W082 as all 3DS consoles.

The label on the WiFi daughterboard differs slightly from most models, but the board itself is the same DWM-W082 as all 3DS consoles.

In any case, this board does look more or less the same as any other model besides the fact that it has integrated IR and some silver screws in a few locations that normally have black screws. The color of the screws does differ from model to model, but I’ve never seen silver screws in these locations before. It’s fairly common for the external screws for the housing to be silver on special edition or bundled consoles, but I’ve never seen anything other than black for the screws beneath the SD card slot. Additionally, some special edition and bundled consoles have only two, rather than three, screws securing the L button in place and only three, rather than four, screws for the R button. This console follows that pattern but it also replaces the normal black screws for the shoulder buttons with silver ones.

Silver, rather than black, screws beneath the SD card slot.

Silver, rather than black, screws beneath the SD card slot.

Silver, rather than black, screws for the shoulder buttons as well

Silver, rather than black, screws for the shoulder buttons as well

Unfortunately, the previous owner used super glue in a misguided attempt to repair the cracked housing and even glued the battery cover in place, leaving no possibility of salvaging it. But the serial number sticker inside was still legible:

DSCF9143

For now I’m keeping this board. I put it inside one of my own consoles and sold the motherboard it replaced. I’ll probably keep it around for a while to tinker with and maybe I’ll eventually sell it.